Your Contour Gauge · 10″ + 5″

Get a perfect copy the first time.

Two minutes here saves a wasted cut. Read the quick start, activate your Lifetime Guarantee, and start copying profiles like a pro.

Copies any profile10″ + 5″ setLifetime guarantee
ShoppingLand Contour Gauge set — 10 inch and 5 inch profile duplicators

Quick start

Four steps to a clean copy.

  1. Zero the pinsPress the pins flat on a flat surface so they start even.
  2. Press firmlyPush the gauge straight onto your shape (tile, molding, pipe, corner) so every pin seats fully. Light pressure leaves gaps.
  3. Lock before you liftSlide the lock to hold the profile — then lift. Move it before locking and the shape can shift.
  4. Trace & cutLay the captured profile on your material and trace.

It copies a shape to trace — it doesn't read out an angle or number. Span is 10″; for wider gaps, capture in overlapping sections; finish tight inside corners by hand on your trace line.

How to use it

Copy · lock · trace · finish.

ShoppingLand Contour Gauge in use: 1 copy the shape, 2 lock, 3 trace, 4 finished cut

1) Copy the shape · 2) Lock · 3) Trace · 4) Finish.

What you can do with it

Contour gauge uses: baseboards, table legs, molding, pipes, stair treads

Prefer video?

Helpful technique video from the maker community (not affiliated with ShoppingLand).

Owned by you

Activate your free Lifetime Guarantee.

Register your gauge and we'll back it for life against manufacturing defects — plus we'll email you setup tips. Takes 30 seconds.

Support

Something not right? We'll make it right.

We're a small US-based team in Fort Lee, NJ. If you can't get a clean copy — or anything's off — reach out and we'll help you dial it in.

Order help: Amazon Buyer-Seller Messaging.
Product & warranty help: ray@shoppingland-usa.com

Your review helps

Found it useful? Say so.

Share your honest review on Amazon — good or bad. Your real experience helps other DIYers and woodworkers choose with confidence.

Write a review on Amazon